Fan TT 315 U, 2350 m3/hr

MOTOR:
The single-phase ball bearing motor has two speeds that can be switched via an external switch. The motor is equipped with a thermal fuse with automatic restart. IPX4 degree of protection.

USE:
The Vents TT 315 U fully meets the requirements for high pressure yet low noise. The fan finds its application in areas with very high humidity such as greenhouses, nurseries, cellars, public toilets, factory kitchens, archives, etc. Thanks to its technical parameters, it is designed for extraction in ductwork up to 65 metres. This fan with electronic temperature sensor and controller is used for automatic speed control depending on the air temperature in the ventilation duct or inside the room.

TERMOSTAT:
If the temperature rises 2°C above the thermostat set point, the fan will automatically switch to a higher speed. When the set temperature is reached, the fan switches back to a lower speed and continues to extract.

INSTALLATION:
The fan can be installed at any point in the duct system - horizontally. In addition, several fans can be installed simultaneously to increase the pressure or capacity of the transported air. The fan body is equipped with a mounting plate for wall mounting.

Technical parameters:
- diameter: 315 mm
- air flow: 1760/2350^m3/h
- ball bearings: yes
- max temperature: 60 °C
- speed: 1980/2660 min
- static pressure: 425/645 Pa
- acoustic pressure: 49/58 dB/1m
- power supply: 230/50 V/Hz
- power input: 225/320 W
- rated current: 0.92/1.43 A
- protection: X4 IP
- weight: 11.4 kg
- lifetime: 40,000 hours

This product is supplied with a power cord.

Here you can find the datasheet.