GSE Satellite driver 6 steps 1.5A – step controller

Product detailed description

This G-SE Satellite Driver six-step (slave controller) expands your fan installation by 350 W and enables speed switching between 6 steps. Connect it to a fan controller (master controller) with an EC output of 0-10 V or a PWM signal.

This satellite controller is based on a transformer (voltage controller), thereby eliminating fan humming. It has two RJ45 connectors, one for signal input and the other for signal output, so you can connect another satellite and expand the AC fan installation, always controlled from the main device.

With 2 jumpers inside, you can choose
1. To switch between Off or step 1 to maintain the fan's minimum speed, in most cases you will use this on the extract fan to prevent odours from escaping and negative pressure from forming in the room.

2. You can choose to start 1 step behind to create negative pressure when controlling the intake fan.
(Explanation: If you use a satellite six-step transformer, you cannot connect the intake satellite directly to the main fan controller; the intake and extract satellites will not switch simultaneously at the same time. To solve this problem, connect both satellites in series and set one of them to run 1 step behind the other.)

GSE Satelite Driver technical specifications
- housing W x H x D = 130 x 92 x 105 mm
- controller W x H x D = 160 x 130 x 105 mm
- designed for 1.5 A / 350 W / 6-step transformer
- voltage 230 V / 50 HZ
- protection class IP54