Aqua Master Tools replacement electrode/probe for pH/EC metre P110 PRO

Product detailed description

The combined P110 pen handles both pH and conductivity with a single probe. The replacement AMT1014 electrode will restore both measurements to the metre you already have - you do not need to buy a new device for this.

Compatibility

The electrode is designed for P110 PRO and P110 PRO 2.0. Each pen has its own spare part, so this electrode fits only the P110.

Two measurements in one body

The pH and conductivity sections are both housed in one probe on the P110, so the electrode is replaced as a whole. After each immersion, rinse it with clean water, even if you are in a hurry.

Calibration after replacement

First pH: two-point with pH 4 and pH 7 solutions. Then the conductivity section, for which EC 1,413 solution is suitable. Without both steps, the new electrode will not show its accuracy.

Storage and warranty

The P110 is among electrodes with dry storage, so you do not need to buy a container with KCl solution for it. The warranty on the electrode is 6 months from purchase and this is a realistic limit for a claim.

Parameters

• Type: replacement pH, EC and temperature electrode
• For models: P110 PRO and P110 PRO2
• Article: AMT1014
• Storage: dry, without solution
• Warranty: 6 months

Frequently asked questions

Can the pH and conductivity sections on the P110 be replaced separately?

No. The P110 pen has both measurements in one probe, so it is replaced as a whole under the designation AMT1014. Separate pH and EC electrodes are available for larger devices - the P700 bench combined metre and H600 Pro handheld monitors, where each is bought separately.

Does the electrode from the P110 fit the P160?

No, each of these models has its own part - the P110 uses AMT1014, while the P160 uses AMT1019. The pens differ in their range of functions, and the P160 also calculates PPM and TDS. When ordering, therefore, follow the model designation on your metre, not the similar appearance of the probe.