IN03 - air ioniser

Product detailed description

IN03 - the air ioniser has been successfully tested by the National Institute of Public Health and is used to enrich the air with negative ions. The device is a high-performance generator of negative ions and covers even larger rooms up to 150m3. When staying in the room, we recommend keeping at least a distance of 2.5 metres from the ioniser. A main switch is located on the body. No harmful ozone was detected in the IN03 ioniser; it emits negative ions into the space using special high-voltage emitters (brushes) made of carbon fibres, which intensively ionise the air. The produced ions (anions) are colourless and odourless (note: do not confuse them with ozone).

• Use of the ioniser:
  - in everyday life, you can use it to neutralise odours and enrich the air with negative ions in work rooms, hospitals, at home and similar places
  - everywhere electrical and electronic devices are used, positive ions (cations) are created by electrostatic charges; these cations cause increased nervousness and fatigue
  - thanks to the formation of anions, the device enriches the air and balances them with positive ions, improving the breathability of the air
  - suitably chosen ionisation reduces the production of NH3 (ammonia), NO2 (nitrogen dioxide), H2S (hydrogen sulphide), CH4 (methane), N2O (nitrous oxide), CO2 (carbon dioxide), dust particles in animal production and further leads to improved condition and reduced medication consumption in animals
• Measured concentrations of light negative ions from one emitter: Distance from the emitter Average concentration of negative ions Space 50cm 3.0 x 10⁵ 1cm³ 100cm 8.0 x 10⁴ 1cm³ 150cm 2.8 x 10⁴ 1cm³ 200cm 1.2 x 10⁴ 1cm³ 250cm 4.8 x 10³ 1cm³ 300cm 1.3 x 10³ 1cm³ 350cm 7.5 x 10² 1cm³ 400cm 5.4 x 10² 1cm³
• Installation of the ioniser:
  - fit and replace the emitter carefully
  - disconnect the device from the mains by hand
  - the carbon fibre brush is very fragile
  - the ioniser produces high voltage even with minimal current
  - install the device directly into the ventilation ducting, preferably behind the filter
  - the device must not come into contact with water or other liquids
• Maintenance of the ioniser:
  - always observe safety precautions during maintenance and switch off and disconnect the device from the mains before handling it
  - the emitter (brush) may become dirty over time; it can be cleaned by vacuuming or scraping, or replaced with a new one
  - do not use the ioniser in contradiction with these instructions
  - apart from cleaning the brush, the device requires no maintenance
  - do not use any abrasive agents or chemical solvents (paint and varnish thinners), as they may damage the surface
  - mechanical cleaning is recommended

You can also purchase NA100 - replacement emitter for IN03 for the ioniser.


Technical parameters:
- power supply - 230V, 50 Hz
- consumption - up to 2 W
- room size - up to 150 m3
- main switch - with LED indication (signals connection to the mains)
- supply cable with plug - 3 metres
- operating temperature - from -20°C to 70°C
- operating humidity - 0% to 70% RH (non-condensing)
- storage temperature - from 0°C to 45°C
- emitter (brush) material - carbon fibres
- emitter (brush) size - diameter 12mm, length 31mm
- box size - 170x120x85mm
- surface or wall mounting (brackets)
- weight - 900 g
- box - ABS
- protection rating - IPXX
- RoHS