GSE Satellite driver 6 steps 1.5A

This six-step G-SE Satellite Driver (slave driver) will extend your fan installation with 350W of power and allows you to switch speeds between 6 steps. Connect it to a fan controller (master-controller) with a 0-10V EC output or PWM signal.

This satellite controller is based on a transformer (voltage regulator), thus eliminating fan hum. It has two RJ45 connectors, one for signal input and the other for signal output, so you can connect another satellite and extend your AC fan installation always controlled from the master device.

With 2 jumpers inside you can choose
1 To switch between Off or Step 1 to keep the fan speed to a minimum, in most cases you will use this on the exhaust fan to prevent odors from escaping and creating a negative pressure in the room.

2. you can choose to run 1 step behind to create a vacuum while controlling the exhaust fan.
(Explanation: if you are using a satellite six step transformer, you cannot connect the intake satellite directly to the main fan control, the intake and exhaust satellite will not switch together at the same time. To solve this problem, you connect both satellites in series and tell one of them to run 1 step at a time.)

Technical Specifications GSE Satellite Driver
- housing WxHxD = 130x92x105mm
- driver WxHxD = 160x130x105mm
- designed for 1.5A / 350W / 6 stage transformer
- voltage 230V / 50HZ
- protection class IP54