MTJ3 - Digital Thermostat, 2 Sockets (Heating/Cooling)

Product detailed description

The Malapa MTJ3 is a digital thermostat for independently switching the connected heating and cooling devices according to the room temperature. It turns the heater on when the temperature drops below the ideal and smoothly increases ventilator speed when it rises. The temperature settings for the two sockets are independent - you can set a different ideal temperature for the ventilator and ventilator. The lowest and highest speed of the ventilator is adjustable.

The LCD screen shows the current temperature, optimal temperature and whether the connected appliance is on or off. If there is any fault in the connected device, the thermostat or the sensor, an optical and acoustic alarm turns on. The device is protected by a fuse. The package includes a temperature sensor on a 1,5m cable, a 3m power cable and brackets for attaching the thermostat to a wall. 

The temperature sensor can be placed in a different room than the regulator. We recommend placing the sensor approximately 1,5m above the floor in a spot with good air circulation and outside the direct reach of any heat emitter.

Socket 1:

• controls the heater according to the temperature
• normally open (NO)
• maximum resistive load: 2600W (11A)
• temperature settings: 0°- 80°C 
• hysteresis settings: 0° - 10°C 

Socket 2:

• controls the ventilator according to the temperature
• normally closed (NC)
• maximum inductive load: 900W (3,9A)
• min. speed settings: 0-100%
• max. speed settings: 0-100%
• temperature settings: 0°- 80°C 
• hysteresis settings: 0° - 10°C 

MTJ3 Specification:

Temperature sensor: digital, calibrated (manufacturer: DALLAS)
Sensor cable length: 1,5m
Sensor size: diameter 10mm, length 60mm

Power input: 230V AC 50Hz 
Maximum total load: 3000W (13A)
LCD screen: 2 lines
Control button: 3x
Operating temperature: -20° to 70°C 
Operating humidity: 0-90% RH (non-condensing)
Data backup: 35 years
Fuse: temperature, electronic
Power cable length: 3m
Installation: wall-mounted (includes brackets)
Total weight: 1029g
Size: 170 x 120 x 85mm 
Storing temperature: 0° to 45°C 
Ingress protection: IP44 (resistant to splashing water)
Casing: ABS plastic, RoHS

If you'd like to customise the product (menu language settings, cable lengths, switched loads, etc.), contact us at info@higarden.eu. We can place an individual order with the manufacturer and adjust the product to your exact needs.